Ecore E-Finish, 1-Gallon

Use Ecore E-Finish, 1-gallon, to add a low sheen and protection to Ecore Recycled Rubber, LVT and Homogeneous Vinyl Sheet floors in an environmentally friendly formula. EFinish provides a tough, black-mark resistant shine with no-powdering for use in commercial facilities. Excellent finishing results with all maintenance systems, including scrub and recoat, spray buff, and burnish. Follow finishing and cleaning directions provided by Ecore, for your specific Ecore floor, in the Ecore flooring material technical manual - download from the Ecore website. E-Finish contains no heavy metals, formaldehyde, phthalates or urethane. Non-toxic. No added fragrance. Meets Federal VOC Requirements. Meets ASTM D2047-93 requirements for slip resistance. Coverage is 1500-2500 square feet per gallon. First coat of E-Finish on uncoated rubber flooring will be approx 1,500 square feet with subsequent coats at 2,000-2,500 square feet per gallon.

ECORE E-Finish SDS
ECORE E-Finish Product Data Sheet

Application Guidelines:

1. Remove old flooring finish using E-Strip following applicable instructions. Rinse floor thoroughly and allow to dry.
2. Apply a minimum of 3 coats of finish. Allow dry time between coats, approx 30-45 minutes. Adjust drying time based on site conditions.
3. For higher gloss level, apply 2-3 additional coats of E-Finish.
4. Burnishing or buffing between coats may produce additional clarity to finish.
Floor sealer not required. Do not apply when flooring and/or ambient conditions are less than 55°F (13°C).

To maintain E-Finish:
Sweep & dust mop daily. Damp mop or autoscrub routinely with E-Clean diluted 1-2 ounces per gallon of water. Deep scrub floor to clean as required. Fit autoscrubber with appropriate machine pad per flooring manufacturer instructions.